RC2800PP-PROP PITCH CONTROLLER

SPECIFICATIONS

Model Number	RC2800 (AZ)
Power Requirements	115 / 230 VAC @ 3/ 1.5A, Switchable
Size	8.5 "W x 5" H x8.5" D
Weight	13 lbs.
Color	Light Gray
Digit Size	5" for Heading, . 375" for Mode / Speed
Control Switches	Tactile 1/2" Diameter, Flush
Input Filters	Yes
Microprocessor Type	Phillips P80CLS8HFH
Digital Display	Indicates Mode, Speed Azimuth / Programming Data
Controls	Power Switch, On / Off
	Speed Buttons, Increments 1-9
	Clockwise & Counterclockwise Buttons, Up & Down
	Mode Button
Modes	3 Operational / Run Modes & 17 Program Modes
Standard Outputs Volts	33 VDC @ 12A, Others Optional
Gear Ratios up to	32,000:1

GENERAL OPERATION INFORMATION

"MODE" BUTTONS" The Mode are used to cycle through and select among 3 operationa or "RUN" modes, and 17 "PROGRAM" modes.

RUN MODE 0: The manual operation mode. When the CW or CCw button is depressed, the positioner ramps up from minimum programmed speed to the maximum (9) and stops, without rampdown, when the button is released.

RUN MODE 1: The manual preset mode. The CW and CCW buttons are used to cycle the display up or down from the current heading. After the button is released, the positioner ramps up from the minimum programmed speed and rampsdown to stop at the selected heading.

RUN MODE 2: The programmable preset mode. The CW and CCW buttons are used to cycle the displaythrough 10 preset, preprogrammed headings. After a short pause, the positioner ramps up from the minimum programmed speed and ramps down to stop at the selected heading.

PROGRAM MODES: Modes 3 through 9 are used to calibrate and configure operations. Modes 20 through 29 are reserved for 10 preset headings.